Description:

Multicrete Concrete Block Paving Joint Filler Sand Stabiliser 5 Litre

Jointing Sand Stabiliser is a water miscible liquid which stabilises the joint filling sand used with concrete block paving, impeding the unwanted erosion of the sand and preventing ingress of water.

Sand Stabiliser Application:

• Joints should be full and the surface dry and swept clean
• Dilute 1 part solution to 6 parts clean tap water
• Spread over the entire paved area using either a watering can with fine rose or suitable spray equipment at a rate of 1 litre (diluted) to 7.5m² (5 litres undiluted makes 35 litres when diluted)
• It is recommended that Multicrete Products Jointing Sand Stabiliser should not be applied if heavy rain is expected within approx' 12 hours

Sand Stabiliser Handling & Storage:

Keep above the chemicals freezing point to avoid rupturing the container. Keep container tightly closed. Do not use storage vessels or pipework made of aluminium, copper or its alloys.  

First Aid Measures:

Inhalation

May cause dizziness or headache. Remove to fresh air

Ingestion

DO NOT induce vomiting. Get medical attention immediately

Skin Contact

Rinse the skin immediately with lots of water. Get medical attention if irritation persists after washing

Eye contact

Promptly wash eyes with plenty of water while lifting the eye lids. Get medical attention immediately. Continue to rinse.
 
Health & Safety Data Sheet available on request
 
Jointing Sand Stabiliser should only be used on concrete block paving. It SHOULD NOT be used on concrete flags or Clay Pavers